An Acrow prop is a piece of construction equipment. It is a telescopic tubular steel prop, used as a temporary suppor...
An Acrow prop is a piece of construction equipment. It is a telescopic tubular steel prop, used as a temporary support. Acrow props are adjustable for height by a large diameter screw thread, formed on the outside of the tube itself. The screw thread provides a fine adjustment over a short range. A loose pin through a series of holes in the inner tube gives a wider range of coarse adjustment. Use of a screw thread also allows the props to be tightened when already in place, to adjust the load that each one bears.
Props are made in a range of five standard sizes:
size 0 from 1.041 metres (3 ft 5.0 in) to 1.829 metres (6 ft 0.0 in),
size 1 from 1.753 metres (5 ft 9.0 in) to 3.124 metres (10.25 ft),
size 2 from 1.981 metres (6 ft 6.0 in) to 3.352 metres (11.00 ft),
size 3 from 2.590 metres (8 ft 6.0 in) to 3.962 metres (13.00 ft),
size 4 from 3.200 metres (10.50 ft) to 4.876 metres (16.00 ft).
The safe load for each prop is a maximum of 35 kilonewtons (7,900 lbf), reducing slightly when props are fully extended, or by up to half when the load is not perfectly vertical.
Acrow props are mostly used for shoring: temporary supports during building repair or alteration work, rather than scaffolding: access platforms for workers. A typical use is to support an existing horizontal beam whilst its original masonry supports are removed or repaired. When masonry itself is to be supported, holes are first knocked through the brickwork and a strong 'needle' or 'strongboy' is placed through the hole. A pair of Acrow props are then used, one under each end. Existing windows or doorways may also be supported directly, or via needles.
The base and top plate of Acrow props are quite small, so they are suitable for supporting a vertical load but are at risk of toppling if there is any sideways force. In such cases, props should be strutted or 'laced' with scaffolding poles. A recent improvement to Acrow props was to shape this baseplate with notches, allowing pallet loads of horizontal props to be stacked neatly, rather than randomly piled.